Fluke FiberInspector Pro FI-3000 User Manual page 11

Set the Key Position in the App to make the fiber numbers on the image of the
endface on the display agree with the fiber locations of the connector. This is
called fiber number agreement. To set the key position, see
Access Toolbar.
The key position on an adapter affects the location of the fiber numbers on
image of the test result.
With an adapter attached to the tip, to see the correct numbers for the fibers in
the test results:
• For an opposed key adapter, set Key Position to the key position on the
Probe.
• For an aligned key adapter, set Key Position to the opposite side from the
key position used on the Probe.
With Key Position set correctly for the type of adapter, fiber number 1 shows
on the top left of the image on the display.
If you rotate the adapter or tip on the probe, change the key position
to Key Left or Key Right, as appropriate to maintain fiber number
agreement.
Figure 4 shows the key on the left side of the Probe and Key Position set to
Key Left in the App to test connectors in a patch panel with opposed key
adapters.
Figure 4. Key Left Position with Opposed Key Adapter
Note
Table 9. Quick
7