Installing The Pcie Card Holder - Dell DR4300e Owner's Manual

Related Links
Safety instructions
Before working inside your system
Removing an expansion card from expansion card riser 2 or 3

Installing the PCIe card holder

Installing an expansion card into the expansion card riser 2 or 3
After working inside your system
Installing the PCIe card holder
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
CAUTION: Do not use your system without the PCIe card holder installed. The PCIe card holder is
necessary to ensure proper system cooling.
Steps
1. Align the PCIe card holder with the notches and tabs on the power supply unit cage.
2. Press the release tab and slide the PCIe card holder toward the front of the chassis until firmly seated.
Figure 26. Installing the PCIe card holder
1. PCIe card holder
Next steps
1. If applicable, replace the full-length PCIe card.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Installing an expansion card into the expansion card riser 2 or 3
After working inside your system
92
2. release tab