Removing The Riser 1 Blank - Dell DR4300e Owner's Manual

Figure 36. Installing an expansion card into the expansion card riser 1
1. tab A
3. expansion card connector
5. latch
Next steps
1. Install the expansion card riser.
2. If applicable, connect any cables to the expansion card.
3. Follow the procedure listed in the After working inside your system section.
4. Install any device drivers required for the card as described in the documentation for the card.
Related Links
Safety instructions
Before working inside your system
Removing expansion card risers
Installing expansion card risers
After working inside your system

Removing the riser 1 blank

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
106
2. expansion card riser 1 cage
4. tab B
6. expansion card