Removing And Replacing The Alert Transducer Assembly - Motorola Talkabout 191 Service Manual

Disassembly

Removing and Replacing the Alert Transducer Assembly

G
23
1. Remove the battery, SIM, and rear housing as described in the procedures
2. Using the flat end of the disassembly tool, carefully pry the transducer from
its cavity in the rear housing as shown in Figure 13.
DISASSEMBLY
TOOL
Figure 13. Removing the alert transducer assembly
The alert transducer is fastened to the rear housing with adhesive. Exercise care
when removing to prevent damage to the rear housing.
3. To replace, remove the protective backing from the new transducer, then press
the transducer into place in the rear housing cavity. Be sure the transducer is
straight, fully seated in its cavity, and positioned so its terminals will contact
the transceiver board when reassembled.
4. Replace the rear housing, SIM, and battery as described in the procedures.
October 23, 2001
ALERT
TRANSDUCER
ASSEMBLY
Product Family C25
.
REAR
HOUSING
010705-o
6881039B15