Table of Contents
Advertisement
Level 1 and 2 Service Manual
Removing and Replacing the Vibrator and Vibrator Grommet
6881039B15
1.
Remove the battery, SIM, and rear housing as described in the procedures
REAR HOUSING
DISASSEMBLY TOOL
VIBRATOR ASSEMBLY
VIBRATOR
VIBRATOR GROMMET
Figure 12. Removing the Vibrator and Vibrator Grommet
2.
Using the flat end of the disassembly tool, carefully pry the vibrator assembly
from its cavity in the rear housing as shown in Figure 12. The assembly should
come away from the rear housing easily.
3.
Separate the vibrator from the vibrator grommet.
4.
To replace, insert the vibrator into the grommet. Ensure the vibrator shaft can
to rotate freely.
5.
Align the vibrator assembly with the rear housing so the vibrator terminals
will contact the transceiver board contacts when reassembled, then press into
place until fully seated.
6.
Replace the rear housing, SIM, and battery as described in the procedures.
October 23, 2001
Disassembly
.
010704-o
22
Advertisement
Table of Contents
Troubleshooting
