Specifications - Panasonic DL-EH30SE-W Operation Instructions Manual

Electric bidet seat (household use)
Hide thumbs Also See for DL-EH30SE-W:
Table of Contents

Advertisement

Specifications

Item
Water supply
Rated Voltage
Rated frequency
Rated power consumption
*1
Surface temperature
during occupancy
Seat
Safety device
Deodorizer
Deodorization
device
Suction air volume
Max. flow rate
Flow adjustment
Standard water
Showering
temperature
device
Heating method
Warm water tank volume
Safety device
Air volume
Warm air
Temperature adjustment
device
Safety device
Other safety devices
Operating range of water pressure
Operating range of water temperature
Standard dimensions(L×W×H)
Standard weight (net)
*1: The total power consumption is measured at the ambient temperature of 20±5 ℃.
*2: The temperature on the temperature measurement spot near warm air outlet in company internal test.
*3: The showering operation may be less effective when any water pressure not within the range is used.
The control range of water pressure may be restricted under this water pressure condition ≧147kPa
Reminders
Make sure to inspect and service your electric bidet seat regularly!
●Water leak (at the piping connection or
inside the body)
●Electric bidet seat or seat cracked or
damaged
●Unexpected sound or burning smell
●When pulling the power cord, power is
supplied intermittently
●Unexpected heating of the power plug or
cord
●Unexpected heating of the electric bidet
seat or operating unit
●Other errors or malfunctions
Date of purchase
Notes
Remember to
write down
Dealer
your
Model
"Off" Ambient temperature. 3 positions: "Low" roughlyat 34 ℃,
"Mid" roughly at 38 ℃ and "High" roughlyat 40 ℃
Rear showering: 0.65 L/min
"Off" the temperature of tap water. 3 positions: "Low" roughly at 37 ℃,
"Mid" roughly at 38.5 ℃ and "High" roughly at 40 ℃
"close": room temperature; 20 ℃(low)~50 ℃(high) (room temperature: 10 ℃)
*2
Electrical leakage protector (built-in), occupancy switch (built-in), backflow prevention device (built-in)
*3
Situation
Year
DL-EH30SE-W
Direct supply from water pipe
220-230 V
50 Hz
463-506 W
Thermal fuse, temperature limiter
Catalytic agent: dual-absorption and deodorization
about 0.1 m
Front showering: 0.65 L/min
3 positions
Heat storage
0.6 L
Thermal fuse,temperaturelimiter
about 0.2 m
Temperature fuse, temperature-limiting device
49 - 735kPa{0.5 -7.5kgf/cm
0  - 35℃(Inlet)0 - 40℃(Ambient)
515 mm
474 mm
×
3.8 kg
To prevent any malfunction or incident,
unplug the power plug. Close the water
inlet valve. Be sure to contact your dealer
or one of Panasonic-operated service
centers for inspections.
Month     Day
 
/ min
3
/ min
3
2
159 mm
×
Stop using the product
Model
27

Advertisement

Table of Contents
loading

Table of Contents