Table of Contents
Advertisement
Instructions of shower wash, warm air functions
*1 About the Occupancy Switch
The purpose of the Occupancy Switch is to detect if the seat is occupied by someone.
Tips
The Occupancy Switch may not be enabled if you sit at the front end of the seat.
→Sit at the center of the seat.
When the Occupancy Switch isn't enabled, for example, the seat isn't occupied or not sitting at the center,
the functions of front and rear showering, warm air will become inoperative.
When the Occupancy Switch can't be enabled, press the Occupancy button for more than 2 seconds to enforce
it to be enabled. (The Occupancy indicator will be on.)
When the Occupancy button is pressed, make sure to press the Rear Showering, Front Showering or Warm air
button within 30 seconds. Otherwise, "unoccupied" will be determined and the Occupancy Switch will be
disabled.
(The Occupancy button is for emergency only. When the switch can't be enabled, contact your dealer or one
of Panasonic-operated service centers.)
On
10
Entry
Press for more than 2 seconds
1
Sit Down
Deodorization starts.
(with motor sound)
[Page 9]
The Occupancy Switch
is enabled
and the
*1
indicator is on.
On
Seating sensor (Built-in)
2
Start Showering
Press
or
to start showering.
First, the nozzle cleans itself.
(The water for nozzle self-cleaning flows
into the toilet bowl.)
Warm water will be sprayed after
approximately 5- 8 seconds to start rear
or front showering.
On
You can adjust the water volume
based on your preference. [Page 12]
Use
1
3
Advertisement
Table of Contents
