When Used At A Later Time - Panasonic DL-EH30SE-W Operation Instructions Manual

When Used at A Later Time

When used at a later time after water is drained...
Check if the system can be operated properly by following the steps below.
1
Open the water inlet
valve to supply water.
Check if no water leak occurs to the inlet filter.
If any water leak is found, tighten the inlet filter securely.
2
Place a layer of plastic film under the seat.
To prevent water from splashing.
3
Plug the power plug and check if the water temperature function is disabled.
If not, press
prevent the water tank from running in idle.
When the Power indicator on the body flashes for approximately 10 seconds, it will become always on.
When the Power indicator on the body is off and the Electrical Leakage indicator is on, unplug the power plug.
After 5 seconds, plug it back.
4
Press
The nozzle extends and the warm water tank of the body begins to pump in water. After approximately 1 minute,
water will flow out from the nozzle downwards. If no water flows out, check if the main water valve is opened or
the water inlet valve isn't opened sufficiently.
5
Press
The nozzle retracts.
20
Shunt valve
Water inlet valve
Close
to disable the function [Page 12] To
or
Open
Inlet filter