Faq - Panasonic DL-EH30SE-W Operation Instructions Manual

Electric bidet seat (household use)
Hide thumbs Also See for DL-EH30SE-W:
Table of Contents

Advertisement

FAQ

Showering water doesn't come out!
Flow of showering water is poor!
Is the water inlet valve closed?
→Open the valve.
Is the hole on the nozzle clogged by scale?
→Clean the nozzle with a toothbrush. [Page 16]
Is the inlet filter clogged?
→Remove the inlet filter and clean the filter
screen with a toothbrush. [Page 18]
Is the user sitting at the front end of the seat?
(If the user is sitting at the front end of the seat,
the Occupancy Switch may not be able to be
enabled and the showering function will not be
activated.) [Page 10]
→Sit at the center of the seat.
→If the Occupancy Switch won't be able to be enabled
even when the user is sitting at the center of the seat,
press the Occupancy button. Then, within 30 seconds,
press the Rear Showering / Front Showering button.
Can the lid or seat be covered with a
fabric cover?
→No.
If a fabric seat cover is used, the Occupancy
Switch may not function properly.
If a fabric seat cover is used, malfunctions may occur.
When showering starts / stops and getting
up from the seat, why does water flow from
around the nozzle to the toilet?
This is the water released for cleaning the nozzle or
adjusting the water pressure.
Within several dozens of seconds after showering stops,
droplets will fall from around the nozzle. These are water
remaining inside the nozzle. This is not a malfunction.
Shunt valve
Water inlet valve Open
Filter screen
If possible, the water volume can be set back
to the mid position after each use.
The last used settings are memorized
automatically. If you want to cancel the memory
mode, configure the following settings.
and
concurrently for more than
→Press
2 seconds.
Flash twice
When you want to resume the mode of
memorizing the level automatically.
→Press
and
concurrently again for more than
2 seconds.
Flash once
During showering, water is sprayed at an
incorrect position that the rear end of the
seat becomes wet!
Is the user sitting too close to the front?
→Sit at the center of the seat.
Due to difference between hip sizes, the
showering position may be different.
→Adjust the sat position.
Urine splashes at the gap (front side)
between the toilet and the seat.
→Excrete inside the toilet.
Why does water flow out next to the nozzle?
→During showering or nozzle cleaning, the water flowing
out next to the nozzle is the one released for water
pressure adjustment. This is not a malfunction. [Page 10]
23

Advertisement

Table of Contents
loading

Table of Contents