Connect The Hardware - ZyXEL Communications P-2302HW-P1 Quick Start Manual

1 Connect the Hardware

1 WAN: Use an Ethernet cable to connect the DSL modem to this port.
2 LINE (P-2302HWL models only): Use the green PSTN line cable to connect the TEL or PHONE jack on a
splitter to this port. If no splitter is provided connect the the telephone jack to this port.
Note: When the P-2302HWL-P1 does not have power, only the phone connected to the PHONE 1 port
can be used for making calls. Ensure you know which phone this is, so that in case of emergency
you can make outgoing calls.
3 ETHERNET: Use an Ethernet cable to connect a computer to this port for initial configuration and/or
Internet access.
4 PHONE 1-2: Use telephone cables (and any telephone adaptors provided with your P-2302HW/HWL-P1)
to connect your telephones to these ports. If you only have one telephone, you should use port 1.
P-2302HW/HWL-P1 Series Quick Start Guide
2