Hardware Connections - ZyXEL Communications PK5001Z Quick Start Manual

Hardware Connections

1 DSL: Use the gray telephone wire to connect your PK5001Z's DSL port
to a telephone jack (or to the modem port on a splitter if you are using
one).
2 ETHERNET: Use the yellow Ethernet cable to connect a computer to an
ETHERNET port for initial configuration and/or Internet access.
3 POWER: Use the included power adaptor to connect an appropriate
power source to the POWER socket. Make sure the power source is on.
4 Push in the POWER button.
5 Look at the lights on the front panel.
• The POWER light blinks while your PK5001Z starts up and stays on
once it is ready.
• Each ETHERNET light stays on if the corresponding ETHERNET port is
properly connected and blinks when there is traffic.
• The DSL light is on when the PK5001Z has a DSL connection.
• The INTERNET light is on when you are able to access the Internet and
blinks when the PK5001Z
Is sending or receiving data. Wait a couple of minutes while your device
checks the connection.
If any of these lights are not on, check your connections and inspect
your cables for dam age. If the lights are still off, contact your local
PK5001Z Quick Start Guide
3