Initial Configuration - ZyXEL Communications P-2302HW-P1 Quick Start Manual

5 POWER: Use the power adaptor provided with your P-2302HW/HWL-P1 to connect an appropriate power
source to this socket.
1.1 LEDs (Lights)
• The POWER light blinks during start-up and is green once the P-2302HWL-P1 is ready.
• Each ETHERNET light turns on if the corresponding ETHERNET port is properly connected.
The lights blink when the P-2302HWL-P1 is sending or receiving data through the correspond-
ing ETHERNET port.
• The WAN light stays on if a physical connection with your DSL modem exists. The INTERNET
light stays on when Internet access is available.
• The PHONE lights stay on when your SIP account is registered and they blink if the receiver is
off the hook.
• The WLAN light turns on when the wireless LAN is ready. It blinks when the P-2302HWL-P1 is
sending/receiving data through the wireless LAN.
If none of the LEDs are on, turn the device off and
recheck your hardware connections.

2 Initial Configuration

1 Open your browser, and go to http://192.168.1.1.
P-2302HW/HWL-P1 Series Quick Start Guide
2 Enter the password 1234. Then, click Login.
3