Table of Contents
Advertisement
Remaining running time
display
When the programme is selected, the
remaining programme time is indicated
in the display window @.
The running time is determined during
the programme by the water
temperature, the quantity of dishes as
well as the degree of soiling and may
vary (depending on the selected
programme).
Time preselection *
* depending on the configuration of
T i m e p r e s e l e c t i o n
your specific dishwasher
You can delay the start of the
programme by up to 24 hours.
Here's how to set up the delay:
Switch on ON/OFF switch (.
1.
Press the timer programming button
2.
P - or +.
The display window @ shows
‹‹h:‹‹m.
Keep pressing the timer
3.
programming button P - or + until
the desired time is displayed.
Press START button X.
4.
The delay timer has been activated.
To clear the specified delay, press
5.
the button P - or + repeatedly until
the display window @ shows
‹‹h:‹‹m.
Operating the appliance en
Programme end
The programme has finished when the
value ‹‹h:‹‹m appears in the display
window @.
Switching off the appliance
Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
About the Eco drying function:
When Eco drying is activated in the
Eco 50° programme, the door opens
automatically when the programme
ends. This ensures the best possible
drying result. Low amounts of steam
may occur. If you install the appliance
under a worktop, fit the supplied
steam protection film * (follow the
procedures in the installation
instructions). The steam protection film
protects sensitive fitted furniture and
worktops from damage by water
vapour. Before opening the appliance,
leave it to cool down for a while in the
remaining programmes when the
programme ends.
33
Advertisement
Table of Contents
