Zeolith Drying; Switching On The Appliance; Remaining Running Time Display; Onboard Computer - Bosch SMI69U75TW Operating Instructions Manual

Zeolith drying

The appliance features a Zeolith
container Zeolith is a mineral which can
store moisture and heat energy and
release them again.
During the washing step this heat
energy is used to dry the mineral and
heat up the rinsing water.
During the drying phase moisture from
the washing compartment is stored in
the mineral and heat energy is released.
This released heat energy is blown into
the washing compartment with dry air.
This accelerates and improves drying.
These processes therefore save a great
deal of energy.
ã
Caution
Please ensure that the intake opening
1J is not obstructed and do not place
any temperature-sensitive utensils in the
lower basket at the rear right side above
the blow opening 1R.
ã
Warning – Risk of injury!
Do not touch the blow opening 1R. The
blow opening becomes hot and,
furthermore, any damage will result in
a chargeable callout by customer
service.

Switching on the appliance

1. Turn on the tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display 8.
4. Press the START button )".
5. Close the door.
The programme starts running.
Operating the appliance
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display 8.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).

Onboard computer

You can switch the onboard computer
(additional programme information) off
or on. Proceed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )"
until : ... is indicated on the digital
display 8.
en
23