Table of Contents
Advertisement
en Operating the appliance
Factory setting
You can reset all settings to the factory
setting.
Switching on the appliance
Turn tap fully on.
1.
Switch on ON/OFF switch (.
2.
The Eco 50° programme has been
preset for environmentally friendly
operation whenever the appliance
starts. This programme remains
selected if no other programme
button 0 is pressed.
Press START button X.
3.
Programme sequence starts.
Note:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° program is a particularly
environmentally friendly program and
well-suited for normally soiled
tableware. It is the most efficient
program in the combination of energy
and water consumption for this type of
conformity with the tableware and
content of the EU European Ecodesign
Directive.
Remaining running time
display
When the programme is selected, the
remaining programme time is indicated
in the display window @.
The running time is determined during
the programme by the water
temperature, the quantity of dishes as
well as the degree of soiling and may
vary (depending on the selected
programme).
32
Time preselection *
* depending on the configuration of
T i m e p r e s e l e c t i o n
your specific dishwasher
You can delay the start of the
programme by up to 24 hours.
Here's how to set up the delay:
Switch on ON/OFF switch (.
1.
Press the timer programming button
2.
P - or +.
The display window @ shows
‹‹h:‹‹m.
Keep pressing the timer
3.
programming button P - or + until
the desired time is displayed.
Press START button X.
4.
The delay timer has been activated.
To clear the specified delay, press
5.
the button P - or + repeatedly until
the display window @ shows
‹‹h:‹‹m.
Programme end
The programme has finished when the
value ‹‹h:‹‹m appears in the display
window @.
Switching off the appliance
Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
When the programme ends,
Note:
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Advertisement
Table of Contents
