Safety instructions Delivery The electrical connection conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 9B. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier.
Safety instructions If you cannot obtain any In daily use information from Read and observe the safety the manufacturer, you must information and instructions not install the dishwasher for use on the packaging above or below these for cleaning and rinsing agents. appliances.
Safety instructions ã= Disposal Warning Risk of explosion! 1. Make redundant appliances Do not add any solvents unusable to prevent to the washing chamber. subsequent accidents. Danger of explosion! 2. Dispose of the appliance in a n environmentally friendly ã= Warning manner.
Protection of the environment Ensure that children do not Protection of the place fingers in the tablet environment collecting tray 1B. Small fingers could become r o n m e n t t h e e n v i i o n o f P r o t e c t caught in the slots.
Getting to know your appliance Appliance interior Getting to know your appliance 1" Interior light * a p p l i a n c k n o w y o u r n g t o G e t t i 1* Cutlery drawer Diagrams of the control panel 12 Top basket...
Water softening system/Special salt To change the setting: Water softening 1. Press programme button 3. system/Special salt Each time the button is pressed, the set value increases by one level; s a l t e m / S p e c i a l n g s y s t s o f t e n i W a t e r...
Water softening system/Special salt Using special salt Using detergents with salt component D e t e r g e n t s wi t h s a l t co m p o n e n t Always refill with special salt immediately before switching on the If combined detergents with a salt appliance.
Rinse aid 3. Close cover until it clicks shut. Rinse aid 4. To prevent excessive foam formation a i d R i n s e during the next rinse cycle, remove any rinse aid which has run over with As soon as the rinse-aid refill indicator P is lit on the fascia, there a cloth.
Utensils Switching off rinse aid refill Glass and utensil damage indicator Causes: If the rinse-aid refill indicator P is Glass type and glass production impaired (e.g. when using combined process. detergents containing rinse aid Chemical composition of the component), it can be switched off. detergent.
Utensils Unloading the dishwasher Pans Bottom basket 9" To prevent water from dripping off the upper basket onto the utensils in the lower basket, it is recommended to empty the appliance from the bottom Hot utensils are sensitive to shock! Therefore, when the programme ends, leave the utensils to cool down in the dishwasher until they can be handled.
Utensils Cutlery drawer F olding spikes * Fo l d i n g s p i k e s Arrange the cutlery in the cutlery drawer * depending on model 1* as illustrated. Separately arranged The spikes can be folded down to utensils are easier to remove after improve arrangement of pans, bowls washing.
Detergent Adjusting the height of the 3. To raise the basket, hold the basket on the sides of the upper edge and basket lift it up. 4. Before re-inserting the basket again, The height of the upper utensils basket ensure that it is at the same height 12 can be adjusted in 3 stages to on both sides.
Detergent Adding detergent If the utensils are only lightly soiled, 1. If the detergent dispenser 92 is still slightly less than the indicated amount closed, press the lock 9: to open of detergent is usually adequate. the detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online dispenser 92 only (insert tablet flat,...
Page 18
Detergent Notes You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue.
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options Information for test institutes HygienePlus * H y g i e n e P l u s Test institutes receive the information for This function increases the temperatures comparability tests (e.g. according to and retains them for an extra long time EN60436).
Operating the appliance Zeolith drying Operating the appliance The appliance features a Zeolith container Zeolith is a mineral which can a n c e a p p l i n g t h e O p e r a t i store moisture and heat energy and release them again.
Operating the appliance Switching on the appliance Optical display while Op t i c a l d i s p l a y wh i l e t h e p r o g r a m me i s r u n n i n g the programme is running * 1.
Operating the appliance Remaining running time End of programme display The programme has ended when the value : is indicated on the numerical When the programme is selected, the display 8. remaining running time of the programme is indicated on the digital The end of the programme is also display 8.
Operating the appliance Automatic switch off after end To change the setting: 1. Press programme button 3. of programme or interior light* Au t o m a t i c s w i t c h o f f / in t e r i o r l i g h t Each time the button is pressed, the set value increases by one level;...
Operating the appliance Interrupting the programme Changing the programme When the START button )" has been 1. Open the door. pressed, the programme cannot be 2. Switch off ON/OFF switch (. changed. The LEDs go out. The programme is The only way a programme can be saved.
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance e n a n c e a n d m a i n t C l e a n i n g and fascia with a damp cloth;...
Cleaning and maintenance Filters Spray arms The filters 1j keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and bearings on the spray arms 1: and the pump. These foreign objects may occasionally block the filters.
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect o d o ? w h a t t F a u l t , the appliance from the power supply. Experience has shown that you can 2.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display @ lights up. Tap turned off. Turn on tap. Tap jammed or calcified. Turn on tap. Flow rate must be min. 10 l/min. when water supply is open.
Page 30
Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart the indicated on the digital occurred. display. appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
Page 31
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 32
Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 33
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Page 34
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
Page 35
Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
Page 36
Fault, what to do? Fault Cause Remedial action Cover on the detergent Detergent dispenser or cover Remove detergent residue. dispenser cannot be guide blocked by sticky detergent closed. residue. Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. detergent dispenser or in therefore detergent is not rinsed the tablet collecting tray.
Customer service Customer service Installation and connection e r v i c e C u s t o m e r s If you are unable to rectify the fault, i o n a n d c o n n e c t l a t i o n I n s t a l please contact your customer service.
Installation and connection Safety instructions Installation Please follow the safety instructions The required installation dimensions can under “Installation”. be found in the installation instructions. Level the appliance with the aid of the height-adjustable feet. Ensure that the Delivery appliance is situated securely on the floor.
Installation and connection Drinking water connection Warm water connection * Wa r m wa t e r co n n e c t i o n 1. Fasten the drinking water connection * depending on model to the tap according The dishwasher can be connected to the installation instructions using to cold or hot water up to max.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost Pr o t e c t i o n a g a i n s t fr o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Page 44
*9000894800* 9000894800 en (9306) 640TV...