Table of Contents
Advertisement
en Fault, what to do?
Fault
Fault code ":ƒ... is lit.
Fault code ":Ġ is lit.
Fault code ":ƒˆ is lit.
A different fault code is
indicated on the digital
display.
(":‹‚ to ":„‹)
p or • appears on the
digital display @. *
Refill indicator for salt )*
and/or rinse aid h is lit.
Refill indicator for salt )*
and/or rinse aid h is not
lit.
Water is left in the
appliance at the end of the
programme.
*Depending on the features of your dishwasher
40
Reason
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
Not a fault!
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special
salt/rinse aid available.
Filter system or area under the
filters 1Z is blocked.
Programme has not yet finished
Remedial action
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly. ~ "Waste water
pump" on page 38
Clean pump and lock cover correctly.
~ "Waste water pump" on page 38
No appliance fault, have the mains voltage
and electrical installation checked.
Switch off the appliance with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off water supply
and pull out the mains plug.
Call customer service and quote the fault
code.
See turboSpeed 20 min. in the chapter
"Overview of programmes". *
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter
"Water softening system/Special salt"
~ Page 15 or "Rinse aid" ).
Check refill indicator, levels.
Clean filters and area underneath.
Wait until programme ends or reset.
Advertisement
Table of Contents
