Remaining Running Time Display; Timer Programming; End Of Programme - Bosch SMV65U60 Instruction Manual

Table of Contents

Advertisement

Remaining running time
display
When the programme is selected, the
programme running time is indicated
on the digital display 8. When the
programme has started, the remaining
running time is displayed on the floor
(only for settings :
The running time is determined during
the programme by the water
temperature, the number of utensils
as well as the degree of soiling
and may vary
(depending on the selected
programme).

Timer programming

You can delay the start of the
programme in 1 hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press the button ` + until
flaching in the timer programming
display X.
4. Press + or – button until the `
displayed time corresponds with your
requirements.
5. Press START button )", timer
programming is activated.
6. To delete timer programming `,
press the + or – button until
indicated on the digital display X.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
and :
).
is
is
Operating the appliance

End of programme

The end of the programme O / :
displayed on the floor – provided the
optical display is switched on and is
visible.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
: .... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting :
5. Press programme button # until
the factory set value :
indicated on the digital display 8.
To change the setting,
1. Press programme button 3. Each
time the button is pressed, the set
value increases by one level; when
the value of :
the display jumps back to :
2. Press START button )", the set
value is saved.
3. Close the door.
Note
Depending on the setting for "Automatic
switch off when programme ends or
interior light", the optical display is no
longer or only briefly visible.
en
.
is
has been reached,
(off).
23
is

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sb seriesSm series

Table of Contents