Connecting The Rtd/Prt - Emerson FB2100 Instruction Manual

FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
Figure 3-7.
1
3.6

Connecting the RTD/PRT

EXPLOSION HAZARD: Ensure the area in which you perform this operation is non-
hazardous. Performing this operation in a hazardous area could result in an explosion.
The flow computer supports 2-wire, 3-wire, and 4-wire operation for a PT100 RTD. Route
the RTD cable through the conduit fittings and connect them to their terminal blocks (as
shown on
Note
The device defaults to the 4-wire RTD configuration; you can change this setting in
FBxConnect.
74
Pulse Input (PI) Wiring [DI/DO/PI1 & DI/DO/PI2]- (I/O Option 2)
Open Drain Type or Open Collector Device (Externally Powered)
DANGER
Figure 3-8, Figure 3-9
and
Figure 3-10).
I/O Configuration and Wiring