Replacing The Main Battery Pack - Emerson FB2100 Instruction Manual
Flow computer
Hide thumbs
Also See for FB2100:
- Instruction manual (116 pages) ,
- Safe use instructions (52 pages) ,
- Quick start manual (42 pages)
Table of Contents
Advertisement
3.
4.
5.
5.5
Replacing the Main Battery Pack
Periodically you must replace the main battery pack.
Figure 5-5.
The device provides a battery cable with two pairs of battery connectors, enabling you to
hot-swap the battery pack in a non-hazardous location. You attach the new battery pack
to the free connector (leaving the old one connected), and then disconnect the old battery
pack.
Service and Troubleshooting
Grasp the HMI module and remove it by gently pulling it straight out away from the
unit.
To replace the HMI module, line up the printed circuit board (PCB) with the slot on
the back and gently press it back on. Tighten the four captive fastening screws.
Close the enclosure.
Main Battery Pack
FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
91
Advertisement
Chapters
Table of Contents
