Table of Contents
Advertisement
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
The capacity of this tool is 125 mm diameter x 6 mm thick
grinding or cutting wheels. It is important to choose the
correct guards, backing pads and flanges to use with grinder
accessories. See the Accessory and Guard Applications Chart
for information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the
speed recom mended on the tool warning label. Wheels
and other accessories running over their rated accessory
speed may fly apart and cause injury. Threaded accessories
must have a M14 hub. Every unthreaded accessory must
have a 22 mm arbor hole. If it does not, it may have been
designed for a circular saw. Use only the accessories shown
in the Accessory and guard Applications Chart of
this manual. Accessory ratings must always be above tool
speed as shown on tool nameplate.
WARNING: Handle and store all abrasive wheels
carefully to prevent damage from thermal shock, heat,
mechanical damage, etc. Store in a dry protected area
free from high humidity, freezing temperatures or extreme
temperature changes.
Max.
d
[mm]
D
b
D
b
D
125 6
125 –
Tool Connect™ Chip (Fig. N)
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
Your tool is Tool Connect™ Chip ready and has a location for
installation of a Tool Connect™ Chip.
Tool Connect™ Chip is an optional application for your smart
device (such as a smart phone or tablet) that connects
the device to utilize the mobile application for inventory
management functions.
Refer to Tool Connect™ Chip Instruction Sheet for
more information.
installing the Tool Connect™ Chip
1. Remove the retaining screws
Connect™ Chip protective cover
2. Remove the protective cover and insert the Tool Connect™
Chip into the empty pocket
WALT recommended
e
Min.
Periphical
[mm]
Rotation
speed
hole length
[min.
–1
]
[m/s]
d
22.23
10500
80
–
10500
80
that hold the Tool
20
into the tool.
21
.
22
3. Ensure that the Tool Connect™ Chip is flush with the
housing. Secure it with the retaining screws and tighten
the screws.
4. Refer to Tool Connect™ Chip Instruction Sheet for
further instructions.
Protecting the Environment
Separate collection. Products and batteries marked
w
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end of
its technical life, discard it with due care for our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
After Service and Repair
Threaded
D
WALT service centers are staffed with trained personnel to provide
e
customers with efficient and reliable product service.We do not take
[mm]
any responsibility when you have repaired in unauthorized service
center. You can refer to the leaflet of CONTACT CENTER LOCATOR in
–
product package and contact us through hotline, website or social
media to find the nearest D
–
WALT service center around you.
e
English
17
Advertisement
Table of Contents
