Table of Contents
Advertisement
CONNECTIONS
AM loop antenna
Right channel speaker
e@
Plug the power cord into the AC wall outlet only after all the
connections have been completed.
e@
Be sure to connect an antenna. If you do not, broadcast
signal reception will not be possible.
1 Assemble AM loop antenna.
@ Straighten ends of the twisted wires.
e Assemble as shown in @ when placing on a desk, etc.
e To install in a wall, etc., fix as shown in ©.
Bend outward.
Raise the antenna
and insert the
hook into the slot.
@
Place the antenna on a level surface and rotate it to
find the orientation that yields the best reception.
@ Insert the hook into the slot so
that the antenna is parallel to
the wall.
@® Fix with tapping
screws, etc.
(2) Bend.
6
<RRB1089>
En
Turntable, etc.
Left channe! speaker
To wall outlet
2 Connect AMloop antenna and FM indoor antenna
to the unit's antenna terminals in the same way
as the speaker.
3 Connect the speaker cords to the speaker
terminals.
Connect the red cords to the "+" (red) terminals and the
black cords to the "—" (black) terminals.
e@ With the S-P410V modei, connect the speaker cords to
the speaker system .
@ Twist the wire strands.
@ Push away the tab and
@ Pull back the tab.
insert the cord into the
Be sure to tighten
terminal.
the cords firmly.
NOTE:
Do not allow the conductors of the cords to project out of the
terminals or to come into contact with other conductors.
A
breakdown or failure may occur when conductors touch.
Speaker impedance
Connect speaker systems with a nominal impedance ranging
from 8 to 16 Q.
Advertisement
Table of Contents
