Table of Contents
Advertisement
RECORDING
REVERSE MODE
DOLBY NR
REC PAUSE
30
<RRB1089>
En
A.S.E.S. (Auto Synchro Editing System)
For automatic recording of a CD to a cassette tape.
1 Load the CD.
When programming is performed, tracks will be played in
the programmed order.
2 Load the tape for recording into Deck Il.
Recording should begin in the forward direction ( > ).
3 Set the REVERSE MODE switch.
—
To record on one side of the tape.
=), CD: To record on both sides of a tape.
4 Set the DOLBY NR switch to the desired
position.
5 Press ASES (FADE or DISCO).
FADE:
Fade-out occurs at the tape end.
DISCO: Cross-fade* occurs between tracks and fade-out
occurs at the tape end.
*Cross-fade:
The end of the track being faded out is overlapped with the
beginning of the next track being faded in.
When
the track playing time is less than 1 minute, the
cross-fade operation may not be carried out properly.
FADE
A, B: Indicates the side of the tape.
1 —5: Indicates the number of the track.
**:
Indicates the leader part of the tape.
@ When recording on both sides, and the tape ends in the
middle of a track in the forward ( & ) direction, recording
starts from the beginning of the track when it continues in
the reverse ( <4) direction.
e@
A10-second blank is recorded at the beginning of the tape.
To stop A.S.E.S. during recording:
Press Deck II's STOP button or press the CD STOP button.
@ To resume recording with A.S.E.S.
When the unit finishes A.S.E.S., another CD can be recorded
with A.S.E.S. from that point.
Perform steps 1 through 4. When you want to change to
another CD, press REC PAUSE ( @ #1) and then ASES (DISCO
or FADE).
e
Pressing FADE starts recording without a 10-second blank.
Pressing DISCO rewinds the tape at the normal playback
speed for about 20 seconds and starts recording with
cross-fade.
Advertisement
Table of Contents
