Figure 77. Installing the power button with optional fingerprint reader
Steps
1. Place the power button into its slot on the palm-rest and keyboard assembly.
2. Adhere the fingerprint reader flexible printed circuits to the connector on the palm-rest and keyboard assembly.
NOTE:
This step applies only to computers shipped with a power button with the fingerprint reader installed.
3. Align the screw hole on the power button with an optional fingerprint reader to the screw hole on the palm-rest and
keyboard assembly.
4. Replace the two screws (M1.6x1.7) to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
daughterboard.
2. Install the
WWAN
card.
NOTE:
This procedure applies only to computers shipped with a WWAN card installed.
3. Install the
base
cover.
4. Follow the procedure in
Keyboard
Removing the keyboard
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
solid-state
4. Remove the
WWAN
card.
106
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
drive.
computer.
computer.