Figure 27. Removing the battery cable
Steps
1. Flip over the battery.
2. Peel the adhesive tape that secures the battery cable to the connector on the battery.
3. Hold the battery cable near its connector and gently pull the battery cable up to disconnect it from the battery.
4. Peel the battery cable away from the battery.
Installing the battery cable
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery cable and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
53