Table of Contents
Advertisement
Description & Screws
4
An LED light indicator on the tool will flash each
time a charge is removed.
IMPORTANT:
Connect Discharge Tool Across leads of each
large Capacitor to remove its charge.
5
Remove CNW803 - 20 pin Power Connector on
One Connect Power Supply.
6
Then remove 5 screws at each marked screw
location on the board.
7
Lift off the black Insulator Sheet taped to the
plate assembly at "PULL" marked location.
Be careful not to tear it.
3. Disassembly and Reassemble
Picture Description
3-9
Advertisement
Table of Contents
