Table of Contents
Advertisement
BitStorm 6200 Router User's Guide
9. In the Protocols tab, select TCP/IP, and then click on
10. In the Microsoft TCP/IP Properties dialog box, click in the radio button labeled Use the
following IP address and type 192.168.1.x (where x is any number between 3 and 254) and
255.255.255.0 in the IP address field and Subnet Mask field, respectively.
11. Click on
Panel.
3.2.6
Assigning IP to your PC automatically by DHCP
To use the CPE's DHCP feature (only available in the Model 6211), click in the radio button labeled
Obtain an IP address automatically instead of Use the following IP address in the above
procedures.
By default, the LAN port IP address of the CPE is 192.168.1.1. (You can change this address, or
another address can be assigned by your ISP.)
Note
3.3
Login to your CPE
In this section, you can login to the CPE's web interface by an Ethernet cable, and start to configure
settings and observe some statistics of your Internet connection.
1. Open your Web browser, and type the following URL in the address/location box, and press
<Enter>:
http://192.168.1.1
This is the predefined IP address for the LAN port on the CPE.
A login screen appears, as shown in Figure 3.5.
If you have problem connecting to the CPE, verify that your PC is properly configured within the
subnet of the CPE's predefined IP address 192.168.1.1. See sections 3.2.2 to 3.2.6.
2. Enter your user name and password, and then click on
page of the CPE. The default user name and password are "user" and "user", respectively.
Note
20
twice to confirm and save your changes, and then close the Control
Your PCs must have IP addresses that place them in the same
subnet as the CPE's LAN port.
Figure 3.5 Login Screen
You can change the password at any time. See section 5.3 User
Access.
.
to displayr the home
Advertisement
Table of Contents
