Windows Nt 4.0 - Paradyne 6200 User Manual

3. If TCP/IP does not appear as an installed component, click on
Network Component Type dialog box appears.
4. Select Protocol, and then click
The Select Network Protocol dialog box appears.
5. Click on Microsoft in the Manufacturers list box, and then click TCP/IP in the Network
Protocols list box.
6. Click
You may be prompted to install files from your Windows 95/98 installation CD. Follow the
instructions to install the files.
7. Click on
8. After restarting your PC, open the Control Panel window, and then click on the Network
icon.
9. Select the network component labeled TCP/IP, and then click on
If you have multiple TCP/IP listings, select the listing associated with your network card or
adapter.
10. In the TCP/IP Properties dialog box, click on the IP Address tab.
11. Click in the radio button labeled Use the following IP address and type 192.168.1.x (where
x is any number between 3 and 254) and 255.255.255.0 in the IP address field and Subnet
Mask field, respectively.
12. Click on
Windows. Please click on
3.2.5

Windows NT 4.0:

1. In the Windows NT task bar, click on the Start button, point to Settings, and then click
Control Panel.
2. In the Control Panel window, double click on the Network icon.
3. In the Network dialog box, click on the Protocols tab.
The Protocols tab displays a list of currently installed network protocols. If the list includes TCP/IP,
the protocol has already been enabled, in which case you can skip to Step 9.
4. If TCP/IP does not appear as an installed component, click on
5. In the Select Network Protocol dialog box, select TCP/IP, and then click on
You may be prompted to install files from your Windows NT installation CD or other media. Follow
the instructions to install the files.
After all files are installed, a window displays to inform you that a TCP/IP service called DHCP can
be set up to dynamically assign IP information.
6. Click on
computer.
7. After restarting your PC, open the Control Panel window, and then double-click on the
Network icon.
8. In the Network dialog box, click on the Protocols tab.
to return to the Network dialog box, and then click
to restart the PC and complete the TCP/IP installation.
twice to confirm and save your changes. You will be prompted to restart
and restart your PC again.
to continue, and then click on
BitStorm 6200 Router User's Guide
.
if prompted to restart your
. The Select
again.
.
.
.
19