Epson dreamio EMP-DM1 User Manual page 67

Replacing the lamp
Caution
The lamp is hot immediately after use. Once the power has been switched off,
allow approximately one hour to pass before replacing the lamp to allow it to cool
thoroughly.
1
Turn the power switch off, and when a short beep sounds,
unplug the power cable.
2
Loosen the screws of the lamp cover attachment using the
screwdriver that supplied with the replacement lamp. Slide
the lamp cover horizontally, and then lift it up to remove it.
3
Loosen the lamp attachment screws.
4
Take out the old lamp.
5
Install the new lamp.
65