Table of Contents
Advertisement
Lamp error/Lamp failure/Lamp cuts out/Lamp cover
Red
open
Red
Wait for approximately 1 minute and 30 seconds, and check for a
s
blown lamp.
Clean the air filter and the air intake vent.
The lamp is not broken
The lamp is broken
When using this unit at high altitudes, that is 1500 m or more above sea level, set "High Altitude Mode"
s
to "On".
p. 56
When the
or
High Temperature
Red
alarm
You can continue
projecting in this state.
Orange
Projection stops
automatically if
subsequent high
temperatures are
registered.
Lamp replacement notification
Green
It is time to replace the lamp. Replace the lamp with a new one as soon as possible. Do not continue to
Orange
use the lamp in this state, otherwise it may explode.
When the
or
Standing-by
Orange
During warming
up (Approx. 20
Green
sec)
Projection in
Progress
Green
Cooling down
Orange
(Approx. 5 sec)
Break
Green
p. 65
s
Reinsert the lamp then turn on the main
power switch on the main unit.
Contact your dealer for further advice.
indicators flash orange
Check the 2 items listed.
• Move this unit away from
the wall at least 20 cm.
• Clean the air filter.
s
p. 62
indicators are off
Shows that the unit is ready to be used.
In warm-up mode, pressing
Do not unplug the power cable during warm-up. This may reduce the lifespan of the
lamp.
The operation of all remote control and main unit buttons is suspended during cool-
down. Enters stand-by mode once cool-down has completed.
Do not unplug the power cable during cool-down. This may reduce the lifespan of
the lamp.
Press
p. 62
s
p. 74
Warning
s
p. 65
Normal
has no effect.
to return to normal playback.
If the error continues
s
p. 58
If the condition is not
fixed once the lamp is
re-inserted
: lit
: flashing
If there is no improvement when
you press
and switch the
power on, discontinue use and
disconnect the power cable from
the electrical outlet. Contact your
local dealer or the nearest address
s
provided in the Inquiries.
: lit
: flashing
: off
p. 74
: off
59
Advertisement
Table of Contents
