Vcr Connection And Viewing Setup - Zenith L15V26D Installation, Setup & Operating Manual

VCR Connection and Viewing Setup

- In Video mode, TV automatically reverts to TV mode if the fcr button or flashbk buttons are pressed.
- See following pages to connect to other A/V external equipment to input jacks on the TV.
Connecting a VCR
Connecting a VCR
1
Connections
Connect the audio/video output jacks on VCR to the corresponding input jacks on the TV.
AC INPUT Y
COMPONENT(480i/480p/720p/1080i)
Typical
Antennas
Direct
connection
2 Viewing Setup
Watching TV programs
Turn the TV on and tune to a channel.
Watching VCR
a. Use
tv/video
depending on connection setup: 1 or 2.
- Connection 1: Set VCR switch to 3 or 4 and then tune TV to the same channel number.
- Connection 2: Select VIDEO source input to use Audio/Video In connections.
b. Insert a video tape into the VCR and press the PLAY button.
H/P S-VIDEO
P P
B R
DVD/DTV IN
2
ANT IN
S-VIDEO OUT
ANT OUT
IN
CH3 CH4
(R) AUDIO (L) VIDEO
VCR Connection Panel
button on the remote control to select TV (Ant In.) or Video source,
VIDEO(MONO) L AUDIO R PC INPUT
L
VIDEO IN
1
ANT IN PC
SOUND
+75
15