Vcr Setup; Cable Tv Setup - Zenith Z15LA7R Operating Manual

Installation
External Equipment Connections Continued
External Equipment Connections Continued

VCR Setup

VCR Setup
- A VCR can be setup in two different ways. The most common
connection is Connection 1 but requires the TV to be tuned to channel
3 or 4 to view input from the VCR.
Connection 1
1. Connect the coaxial cable output on the VCR to the antenna input on
the TV.
2. Connect the coaxial cable from the wall to the input on the VCR.
3. Set VCR switch to 3 or 4 and then tune TV to the same channel
number.
Connection
2
1. Connect your cable and/or antenna connection to the input(s) of the
VCR.
2. Connect the audio/video output jacks on the VCR to the
corresponding input jacks on the TV, match the jack colors (Video =
yellow, Audio Left = white, and Audio Right = red).
3. Insert a video tape into the VCR and press PLAY on the VCR.
4. Use the tv/video button on the remote control to select Video.
If connected to S-VIDEO on side panel, select the S-Video external
input source.)
NOTE
In Video mode, TV automatically reverts to TV mode if the fcr button or flashbk buttons are pressed.
Cable TV Setup
Cable TV Setup
- If your cable service does not require a converter box, refer to the Antenna Connection instructions.
- After subscribing to a local cable TV service and installing a converter, you can watch cable TV programming.
- For further cable TV information, contact a local cable service provider.
Connection 1
1. Connect the coaxial cable output on the cable box to the antenna input on
the TV.
2. Connect the coaxial cable from the wall to the input on the cable box.
3. Set the channel switch to 3 or 4 and then tune TV to the same channel
number.
Connection
2
1. Connect your cable input of the cable box.
2. Connect the audio/video output jacks on the cable box to the
corresponding input jacks on the TV, match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red).
3. Use the tv/video button on the remote control to select Video.
If connected to S-VIDEO on side panel, select the S-Video external input
source.
Important Note: If your cable box has Component Video outputs or DVI, it is
recommend you use those connections for the best quality picture.
High Definiton input on this LCD TV is only supported on these two
connections. When using DVI there are three connections to each device,
the DVI cable plus the two audio cables. When using Component there are
five connections to each device, the red, green, and blue video cables plus
the red and white audio cables.
12
H/P
Y P P
B R
AC INPUT
COMPONENT(480i/480p/720p/1080i)
DVD/DTV IN
Typical
Antennas
ANT IN
S-VIDEO OUT
ANT OUT
IN
CH3 CH4
Direct
VIDEO
Connection
S-VIDEO VIDEO (MONO) L AUDIO R PC INPUT ANT IN
+75 Ω
VIDEO IN
2
1
VCR
(R) AUDIO (L)
2 1
Cable Box
PC
SOUND