Operational Contact Removal - IBM Selectric I/O Reference Manual

~
.......
"
..... ~
.......
,~
,...,...ot . . .
_-..::>.~.~
FIGURE 40. Operational Cam Check Pawl and Escapement
Cam Follower Removal
OPERATiONAL CAM FOLLOWER RElv'lOVAL
1. Remove the C -cl ips from the cam-follower pivot shaft
(#1/ Figure 41).
2. Remove the auxiliary cam-follower spring (#2/ Figure41).
3. Work the shaft to the right unti I the desired part is free.
2
OPERATIONAL CONTACT REMOVAL
1. Remove the right rear mounting leg (#1/ Figure 42).
2. Remove the two mounting screws (#2/ Figure 42) and re
move the contact assembly
0
3-11
FIGURE"_ 42. Operational Contact Removal
OPERATIONAL
~vJ\AGNET
ASSEMBLY REMOVAL
1. Perform the Shift-Magnet-Assembly Removal.
2. Remove the actuator-arm spri ng (# 1, Fi gure 43).
3. Remove the two mounting screws (#2, Figure 43).
4. Remove the actuator-arm pivot screw (#3, Figure 43).
5. Remove the armature-link clevises (#4, Figure 43).
6. Remove the mounting screw (#1, Figure 44).
7. Remove the nut (#2, Figure 44) and carefully remove the
magnet assembl y.
FIGURE 43. Operational Magnet Assembly Removal