Table of Contents
Advertisement
2
,2
FIGURE 8.
Belt Replacement
Insert a bristol wrench through the lower left bearing
plate mounting hole over the top of the bail to hold it
down.
13.
Loos~n
the two cycle-clutch latch-bracket mounting
screws.. (#1 , Figure 10). Slip the new belt through the
bearing plate hole, around the shaft
1
and over across
the cycle shaft to the cycle-clutch latch (Figure 11).
Work it between the latch and the cycle-clutch sleeve.
14.
Loosen the motor mount and slip the belt over the cen-
trifugal clutch.
I
• •
•
• .
"
.......
:.
~
------'
FIGURE 9.
Belt Replacement
3-3
FIGURE 10.
Belt Replacement
15.
The following adjustments should be checked after the
belt is replaced:
a.
Idler gears
b.
Damper spring
c.
Filter shaft timing
d.
Print shaft timing
e.
C 1 and C2 contact timing
f.
Cycle clutch latch bracket height
*
Not present on all printers.
FIGURE 11.
Belt Replacement
Advertisement
Chapters
Table of Contents
