Table of Contents
Advertisement
plate as neariy as possible for the prescribed latch to
pusher clearances (Fig.
8).
1.
Pusher Bail Eccentri cs (Fig. 7) - Adjust so that the top
edge of the follower arms are flush with the pusher bail.
These Surfaces Flush
Eccentric
Follower Arm
FIGURE
7.
Pusher Bai
I
• 030
11
to
.040
11
-
R2A
r--
.025
11
to 0035
11
-
T2, T1, R2, Rl, R5
I
~~Pusher
~-~
NOTE:
This adjustment should
Extension
'\i~
0,,-
be made with all parts at rest
(cycle clutch latched).
Form Within Circled Area
FIGURE 8.
Latch Pushers
Latch Extensi on
FiGURE 9.
Pusher Clearance
2-3
2.
Latch Pushers T2, Tl, R2, Rl,
&
R5 (Fig. 8) - Form to
clear their respective latch extensions by .025
11
to .035
11
•
3.
Latch Pusher, R2A (Fig.
8) -
Form to clear latch exten-
sion by .030
11
to .040
11
•
Malselection may be caused by the latch pushers contacting
thei r latch extensions when an unselected pusher is against its
armature. There should be a minimum of .002" clearance
(Fig. 9) between the pusher and the latch extension when the
pusher is against its armature. To check this adjustment, turn
machine power off, trip the cycle clutch, and hand cycle a
few degrees through a cycle. The pusher cam follower should
be on the low dwe
II
of the pusher cam.
PRINT SELECTION MAGNET ASSEMBLY
NOTE:
For complete adjustment, tbe magnet unit should be re-
moved • To prevent interference from the tri p bai I
r
turn
the high points of the pivot eccentrics to the top •
1.
Pivot Plate (Fig. 10) - Adjust for a clearance of .001"
to .006
11
between the yoke and armatures with the arm-
atures manually attracted. Measure clearance of the
outside armatures (T2
&
R5).
Armature
"""'r----Pivot Plate
Yoke
~--Guide
Plate
FIGURE 10.
Pivot Plate
2.
Guide Plate (Fig. 10) - Position as follows:
a.
Vertically - to provide equal spring tension on all
armature springs.
b.
Hori zonta II
y -
$0
that a II armaTures are centered in
the guide slots.
Advertisement
Chapters
Table of Contents
