Carrier And Rocker Removal - IBM Selectric I/O Reference Manual

FI GURE 51. Carrier Shoe Removal
3. Work the carrier out from under the escapement bracket
to the right.
4.
Remove the nut from the carrier-shoe stud and remove
the shoe
(#1,
Figure
51).
5.
The following adjustments should be checked after the
carrier-shoe is replaced.
a. Carrier shoe
b. Escapement bracket
c. Tab
CARRIER AND ROCKER REMOVAL
1.
Remove mounting screws
(#1,
Figure
52).
2.
Remove card holders
(#1,
Figure
53).
3.
Disconnect ribbon lift spring
(#3,
Figure
53).
4. Release rotate spring tension (#4, Figure
53).
5.
Remove tilt pulley spring
(#5,
Figure
53).
6.
Remove tape anchor screw
(#6,
Figure
53).
7.
Remove tapes
(#7,
Fi gure
53).
8. Remove tape wi per (#8, Fi gure 53) if present.
9.
Remove escapement bracket mounting screws
(# 10,
Fi g-
ure
53).
10.
Remove transport spring bracket screw
(#1,
Figure
54)
(Early printers only)
11.
Remove print shaft gear (not shown) .
12.
Remove print shaft
(#11,
Figure
53).
13.
Remove carrier and rocker assembly.
FI GURE
52.
Carrier and Rocker Removal
10
3 -_ _ _
-'~,~
5
FI GURE
53.
Carrier and Rocker Ren:oval
FI
GURE
54.
Carrier and Rocker Removal
NOTE: If rocker removal is necessary, complete the follow-
ing steps:
14.
Remove anvil striker
(#1,
Figure
55).
15. Remove rotate spring, cage and pulley
(#2,
Figure 55).
16.
Remove tape guide
(#3,
Figure
55).
3-14
17.
Remove !I(" ci i p on rocker shaft
(#4,
Fi gure
55).
18.
Loosen rockel- shaft se!' screw and remove rocker shaft
(#5,
Figure
55),
19. Check carrier and rocker and alignment adjustments afte(
reassembly.