Cable Service - Zenith Concierge H20C35DT Installation And Operating Manual, Warranty

Hook Up Cable Service (CATV)
Connect cable service to the TV
Locate the Antenna/Cable jack on the
1
back of the TV.
2
Connect the cable that runs from the wall
directly to this jack, according to the dia-
gram to the right.
Remove the back of the remote and put in
3
two AA batteries.
Plug in the TV. Do not plug it into a
4
switched outlet. Your TV is designed to
operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on
DC Current.
5 Go to page 12 to Auto Program the TV.
If you're using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you're using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don't worry, that's all
you need!
P A G E 8
back of
remote
Cable TV
wall jack
RF coaxial wire (75 ohm)
Cable TV
wall jack
Cable box
In
output
Out
switch 3 4
RF coaxial wire (75 ohm)
TV back
ANTENNA
CABLE
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
TV back
ANTENNA
CABLE
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
206-3489-O