Table of Contents
Advertisement
BEFORE REQUESTING SERVICE
Check the following points once again.
• Check that the Power Plug is completely connected to an AC Outlet.
|
* Check that ће POWER Button is set to "ON".
No operation starts when operation
|e Check the DEW Indicator. If it is displayed, the unit will not operate.
buttons are pressed ...
(p. 34)
RECORDING
AND PLAYBACK
* Check the connections between VCR, externa! antenna and your TV.
* Make sure that the receiving channel of the VCR is memorized.
(p. 32)
* Check that the ANTENNA-SYSTEM
SELECT Button is set to meet
your cable TV system. (p. 31)
* Make sure that the small tab on the back of the cassette is stili intact.
(p. 39)
Timer Recording can't be
* Set the recording start De and recording length correctly.
performed ...
(p. 17—22)
* Make sure that the TIMER Button is set. (p. 19)
e Timer Recording will not be performed or continued if a power
interruption of more than 2 minutes occurs before or during Timer
Recording, even if power resumes thereafter.
• Select the same channel on your TV as that of the CH 3/4 Switch on
the VCR. (p. 9)
• Set ће VCR/TV Selector to "VCR". (p. 9)
e Check that channel 3 or 4 of TV is properly adjusted. (p. 3)
• Adjust the TRACKING CONTROL slowly in either direction. (p. 8)
There is no playback picture, or the
playback picture is noisy or contains
During slow-motion playback, the
picture shows blurred action ...
During special effects playback, the
picture may contain some vertical
jitter when using a TV which has
Automatic venice! Hold Control
Switch ..
• Use the Slow Tracking Control (on the Wireless Remote Control). (p. 8)
e In that case, set the TV's Vertical Hold Control Switch to MANUAL
position and then adjust vertical hold control.
e Because the VCR playback signal is not as stable as an off-the-air
TV signal, you might experience the following symptom on your TV
screen: "Top of TV screen is bent or unstable when VCR is played :
back. This symptom is more noticeable when a pre-recorded tape,
recorded by another VCR, is played back." To solve this problem,
. locate the horizontal hold control on your TV. Tum it slowly to correct
the wavy picture. If your TV does not have the horizontal hold contro!
or adjusting the control does not help, some modifications have to be
made to the TV set. Technically this is called "Horizontal AFC time
constant change." If such a problem is noticed, please contact your
focal TV service center. (Some nominal service charges are required.)
If the top of your playback picture
waves back and forth excessively ...
ad s
Advertisement
Table of Contents
