Table of Contents
Advertisement
Fastener Cap not
resting against spring
Press Down
(4 Places)
NOTE: Thermal Solutions that come with IntelR boxed
processor use pre-applied thermal interface material
Apply Thermal
Interface Material
and not grease.
3.
4.
•
•
Fastener flush
against MB
Both fastener
halves are flush
against spring
Fastener flush
against spring
Remove Heat Sink (HS) from packaging media
Place HS onto the LGA775 Socket
Ensure fan cables are oriented on side closest to
fan header
Align Fasteners with MB through-holes
5.
Inspection
•
Ensure cables are not trapped or interfere
fastener operation
•
Ensure fastener slots are pointing straight out
from heatsink
6.
Actuate fasteners
•
While holding HS to prevent tilting, press down on
fastener caps with thumb to install and lock
Repeat with remaining fasteners
7.
Inspection
•
Verify the fasteners are properly seated
•
Ensure both fastener cap and base are flush with
spring and motherboard
8.
Connect fan header with Board header
9.
Secure excess cable with tie-wrap to ensure
cable does not interfere with fan operation or
contact other components.
14
Advertisement
Table of Contents
