Table of Contents
Advertisement
Skipping the OGM for ICM Recording
If you would like to leave a message on your unit, but do not want to listen to your OGM before
doing so, you can switch directly to the Incoming Message (recording) mode.
Call your unit.
Push "0" during OGM (instead of your
Code No.).
eOne beep will be heard and the unit will go
directly to the recording mode.
e After hearing a long beep, speak clearly and
loudly to record your message.
>
=
m
D
=
o
À
-
x
Turning On the Auto Receiving Mode
a
=
You may turn the unit on from a remote phone using any telephone.
=
Jee..
Call your unit, and wait for 15 rings.
ml
e The unit will answer.
I
[2^
A
s
After hearing the OGM or the beep tones,
DP.
).OGM
l"
BEEP
w=
and then hang up.
ne
N
=>
aan
elt the FUNCTION selector is set to the
|
on
I
TE
ANS/FAX position, the OGM will be heard.
elf the FUNCTION selector is set to the FAX
position, you will hear several "beeps"
(answering carrier tone).
NOTE:
If you hear 6 beep tones after your OGM, the tape is full. Reset the tape. Refer to the procedure of
"Resetting Tape for Future Messages" on page 2-9.
2-12
Advertisement
Table of Contents
