Table of Contents
Advertisement
How to Operate from a Remote Phone
Re-recording the Outgoing Message
You can re-record the Outgoing Message from a remote phone.
1
Call your unit, and press the Code No. during the OGM.
2
Press "7" right after you hear the beep tones indicating the
number of recorded messages.
•Short beeps will be heard continuously until the OGM tape has
been reset, and then a long beep will be heard.
3
Speak clearly and loudly after you hear the long beep.
•Do not pause for over 2 seconds while recording.
4
When recording is finished, press "9".
•The new Outgoing Message will be played back. So you can
check or amend it.
NOTE:
If you pause for over 2 seconds while recording, you will hear a
series of warning tones (6 beeps). If this happens, repeat from step 2
within 10 seconds of hearing these beeps.
Skipping OGM for ICM Recording
If you or the caller does not want to hear the Outgoing Message, the unit can be
switched promptly to the Incoming Message mode.
1
Call your unit.
2
Press
during the OGM.
3
Speak clearly and loudly after you hear the long beep to record
your Incoming Message.
-17
Advertisement
Table of Contents
