Getting Started; Start / Pause / Resume; Spot Cleaning; Recharge - Eureka NER J12 Ultra Instruction Manual

GETTING STARTED

NOTES
1. Make sure that the mopping cloths are installed properly
before use, otherwise the robot will not start normally.
2. This product is intended for indoor use only. Do not use it
outdoors.
3. Do not submerge the robot vacuum in water. Doing so may
damage the equipment, causing a short circuit or current
leakage.
Operation
Briefly Press Start/resume
/pause
Press and
Shut down
hold

Start / Pause / Resume

Briefly Press " " to start/pause/resume cleaning or use your
App to control.
Button
Return to Start spot
the base cleaning
Enable/Disable
/
child lock

SPOT Cleaning

Press " " briefly to start spot cleaning. The robot vacuum will
clean a square-shaped area (1.0m x 1.0m) with the current
location as the center.
1.0m
1.0m

Recharge

Press " " briefly. The robot vacuum will move from the
current location to the self-cleaning base for charging.
Emptying
After cleaning, the robot will return to the self-cleaning base
and automatically begin self-emptying. More self-emptying
settings can be enabled in the app, such as manual emptying.
Avoid manual emptying frequently.

Washing the Mopping Cloth

The robot vacuum returns to the self-cleaning base to wash the
mopping cloth after mopping an area of 10 square meters. You
can manually specify the washing frequency in the app as
required.
After completing a mopping task, the robot vacuum will return
to the self-cleaning base and automatically wash the mopping
cloth. (The washing cycle takes some time to complete.)
18
1.0m
1.0m