Advertisement
2.1
Transport mode
2.2
Diagnostics connector
2.3
Unpacking and setting up the vehicle
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
H02712-01
handing it over to the customer.
Diagnostics connector
H00933-12
Condition
Packaging V3
–
Remove the box and the plastic packaging.
Info
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you
have finished.
–
Remove the separate enclosure and unpack it. Check that
V02692-01
the scope of supply is complete using the enclosed pack-
ing list.
Info
The procedure for missing components is described
in the Customer Service Manual.
–
Carefully loosen and remove the tension belts around the
fork legs.
–
Remove the attachment on the rear wheel.
Info
An assistant prevents the motorcycle from falling over.
–
Have a lift stand available.
Lift stand (78129955100)
1
is located under the seat.
SETUP 2
3
Advertisement
