Husqvarna TC 112 Operator's Manual page 39

to decrease the risk of fire. Let the product
become cool before you put it in storage.
• Clean the product, refer to
page 24 . Repair paint damages to prevent corrosion.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Remove the battery. Clean it, charge it, and keep it
cool during storage.
• Change the engine oil, and discard the waste oil.
• Empty the fuel tank. Start the engine and let it
operate until there is no remaining fuel in the
carburetor.
CAUTION:
tank and carburetor if a stabilizer has
been added.
• Close the fuel shut-off valve.
• Remove the spark plugs and put approximately a
tablespoon of engine oil into each cylinder. Manually
turn the engine shaft to apply the oil and put the
plugs back on.
• Lubricate all grease nipples, joints and axles.
• Keep the product in a clean and dry area and put a
cover on it for more protection.
• A cover for protection of your product during storage
or transportation is available at your dealer.
Disposal
• Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
• When the product is worn out, send it to the dealer
or to an applicable recycling location.
• Oil, oil filters, fuel and the battery can have negative
effects on the environment. Obey the local recycling
requirements and applicable regulations.
• Do not discard the battery as domestic waste.
• Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
1903 - 004 - 18.12.2023
To clean the product on
Do not empty the fuel
39