Husqvarna TC 112 Operator's Manual page 29

Cutting deck
To remove and install the cutting deck
1. Disengage the cutting deck and stop the engine.
2. Put the cutting deck in the lowest position.
3. Remove the 2 screws and the left belt cover.
4. Remove the 2 screws and the right belt cover.
5. Move the drive belt off the left blade pulley to
decrease the tension of the drive belt.
6. Remove the drive belt from the engine pulley.
7. Do the steps that follow to disconnect the front link.
a) Remove the clip (A) and the washer (B).
b) Disconnect the front link (C) from the bracket (D)
on cutting deck.
8. Do the steps that follow to disconnect the 2 rear
links. There is one rear link on the left side and one
rear link on the right side of the product.
1903 - 004 - 18.12.2023
B
A
C
D
WARNING:
heavy. Use a crowbar or equivalent
below the cutting deck to hold the weight
of the cutting deck when you disconnect
the 2 rear links.
a) Remove the clip (E), the washer (F) and the pin
(G) from the left rear link.
G
E
F
b) Disconnect the cutting deck from the left rear
link.
c) Pull and hold the cutting height lever in the
lowest position with one hand. Remove the clip,
the washer and the pin from the right rear link.
WARNING:
cutting height lever. The mechanism
for the cutting height adjustment is
spring-loaded. The force from the
spring can cause crush injury if you
do not pull and hold the cutting
height lever.
d) Disconnect the cutting deck from the right rear
link.
e) Carefully release the cutting height lever.
WARNING:
for the cutting height adjustment is
spring-loaded. The force from the
spring can cause crush injury. Keep
body parts away.
9. Move the cutting height lever to the highest position.
10. For the TC 112 model, do the steps that follow to
disconnect the clutch cable.
The cutting deck is
Do not release the
The mechanism
29