Husqvarna TC 112 Operator's Manual page 20

To set the cutting height (TC 112)
• Pull the cutting height lever in the direction of the
seat and put it in 1 of the notches for the correct
cutting height.
To set the cutting height (TC 114)
• Pull the cutting height lever in the direction of the
seat and put it in 1 of the notches for the correct
cutting height.
To operate the product
1. Start the engine. Refer to
page 18 .
2. Release the parking brake. Refer to
release the parking brake on page 19 .
20
To start the engine on
To apply and
3. Carefully push the forward pedal (A) or the rearward
pedal (B). The speed increases the more the pedal
is pushed down.
Note:
The forward pedal and the rearward pedal
go back to their neutral position when they are
released.
4. Release the pedals to brake.
5. Select the correct cutting height. Refer to
cutting height (TC 112) on page 20 or To set the
cutting height (TC 114) on page 20 .
6. Engage the cutting deck. Refer to
disengage the cutting deck (TC 112) on page 19 or
To engage and disengage the cutting deck (TC 114)
on page 19 .
To use the reverse operation system
(ROS)
Note:
If you try to go rearward with the product
when the cutting deck is engaged, the engine stops
immediately. Engage the ROS to go rearward with the
product when the cutting deck is engaged.
WARNING:
operate the product rearward, look down
and behind the product for the safety of
others.
A
B
To set the
To engage and
Before and while you
1903 - 004 - 18.12.2023