Husqvarna TC 112 Operator's Manual page 30

a) Disconnect the clutch cable (H) from the spring
(I) on the belt tensioner.
b) Remove the clip (J) and pull out the clutch cable
holder (K) from the bracket on the cutting deck.
J
K
11. Push down the lower chute and remove the cutting
deck from the product.
12. Install the cutting deck in the opposite sequence.
CAUTION:
belt is installed correctly and does not
get compressed when you install the
cutting deck.
30
H
I
Make sure that the drive
a) Make sure that the lower chute is in the correct
position when you install the cutting deck.
b) Make sure that the brackets are in the correct
position when you install the cutting deck. The
bracket on the right side (A) must be on the inner
side of the right rear link. The bracket on the left
side (B) must be on the outer side of the left rear
link.
B
To remove and install the center chute
1. Disengage the cutting deck and stop the product.
2. Set the power switch in the off (O) position and
remove the power switch key.
3. Remove the grass catcher.
4. Remove the 2 nuts and 2 washers.
5. Pull out the center chute.
6. Install the center chute in the opposite sequence.
A
1903 - 004 - 18.12.2023