Husqvarna TC 112 Operator's Manual page 15

• Install the tow bar with the 2 screws.
To install the brackets for the grass
catcher
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
1. Install the left bracket with the 2 screws.
2. Install the right bracket with the 2 screws.
To install and adjust the full bag sensor
1. Stop the engine and apply the parking brake.
2. Remove the center chute. Refer to
install the center chute on page 30 .
3. Install the full bag sensor (A) with the 2 screws (B).
C
4. Connect the cable (C). The connector for the cable is
found in the hole for the center chute.
1903 - 004 - 18.12.2023
5. To adjust the full bag sensor, push the lever in or pull
To assemble the grass catcher
1. Install the front frame (A) to the brackets on the top
To remove and
2. Install the strut (E) to the front frame and the top
A
B
the lever out. If the grass is heavy or wet, push the
lever in. If the grass is dry and not heavy, pull the
lever out.
frame (B) with 2 screws (C) and 2 nuts (D) on each
side.
D
F
G
E
G
frame with 2 screws (F) and 2 nuts (G) on each side.
B
C
A
F
15