IBM eServer xSeries 440 Installation Manual page 30

6. Install the DIMM:
7. If you have other options to install or remove, do so now.
8. Close the cover. See "Completing the installation" on page 24.
20
xSeries 440: Installation Guide
DIMM
a. Open the retaining clip on each end of the DIMM connector. Turn the DIMM
so that the pins align correctly with the connector.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
b. Insert the DIMM into the connector by aligning the DIMM edges with the
slots at each end of the DIMM connector. Firmly press the DIMM straight
down into the connector by applying pressure on both ends of the DIMM
simultaneously. Be sure that the retaining clips snap into the locked position
when the DIMM is firmly seated in the connector.
c. If a gap exists between the DIMM and the retaining clips, the DIMM has not
been properly installed. In this case, open the retaining clips and remove the
DIMM; then, reinsert the DIMM.
Note: The installing or removing of DIMMs changes the configuration
information in the server. Therefore, you must change and save the new
configuration information by using the Configuration/Setup Utility
program. Refer to "Using the Configuration/Setup Utility program" on
page 30 for more information.
Retaining
clip