b. Remove the blue thumbscrews holding the EMC shield to the server.
For use with one
SMP Module
c. Remove the EMC shield from the rear of the server.
Note: The illustrations in this document might differ slightly from your hardware.
5. Grasp each of the locking levers on the top of the SMP modules, and lift them
up slightly.
6. Working from the right side of the server, rotate the two locking levers toward
you until they are fully extended, as shown.
EMC shields
Thumbscrews
For use with two
SMP Modules
EMC Shield
SMP baffle
Scalability
Cables
Chapter 2. Installing options
15